Clan x86
General Forums => General Discussion => Topic started by: rabbit on December 11, 2005, 12:34:08 pm
-
I've been told you have CAT5 cable. Will you send me a bunch?
-
MY 300ft CAT5. *hugs*
-
How much do you need? I might be able to box some up. :)
-
If I measured correctly, just about 50' should do, though it may be 60....anyway, is that possible?
-
If I measured correctly, just about 50' should do, though it may be 60....anyway, is that possible?
Yeah, that shouldn't be a problem. PM me with your address and stuff.
Also, do you have module assembly kits and crimpers? This cable isn't pre-crimped.
If not, I can probably take it to school and crimp two ends on and use our certifiers to make sure they work. :)
-
I've had to crimp an entire office together. I even got to test it. The only thing that I failed was the shielding test.
-
Yeah. No, I don't. It'd be awesome if you could setup the connectors.
-
Yeah. No, I don't. It'd be awesome if you could setup the connectors.
Shouldn't be a problem. Do you want male ends on both? Since that's how you roll and all... (just kidding :))
I've had to crimp an entire office together. I even got to test it. The only thing that I failed was the shielding test.
The shielding test? I think that means the wire's too close to an electrical current, if memory serves. Mine would probably fail the attenuation test because it's so long, but most certifiers are built to test CAT-5e cable to run on gig, not CAT-5. The cisco certifications for CAT-5 are a lot more lenient.
-
I'm assuming I'm getting this right: cat5 for normal ethernet cable? I'm not much of a networking person...
And yes, male both ends. There are a couple lesbians that need a two-ended dildo...My router just refuses to wear a strap-on.
-
I'm assuming I'm getting this right: cat5 for normal ethernet cable? I'm not much of a networking person...
Well, kind of. CAT-5 is what I use. It doesn't support gig (1000 MB/s) like CAT-5e and CAT-6 do, but it works fine for 100-BaseT (100 MB/s).
And yes, male both ends. There are a couple lesbians that need a two-ended dildo...My router just refuses to wear a strap-on.
LMFAO
-
Ahh. So apparently I need CAT-5e to take advantage of my gigabit ethernet card? :(
-
I have 10/100. Whatever?
I quit. Just send it to me. If it doesn't work I can go all emo with it. That TP someone's house with it...
-
Ahh. So apparently I need CAT-5e to take advantage of my gigabit ethernet card? :(
Yes. That and a gig switch. And the rest of the computers on your network would have to have gig too (or at least one other).
I have 10/100. Whatever?
I quit. Just send it to me. If it doesn't work I can go all emo with it. That TP someone's house with it...
Yeah, CAT-5 will work perfectly well with 10/100. $ emo --wrists? :)
-
Nah. I've decided I hate my neighbors.
$ delinquent house=/marion/south/102
-
Nah. I've decided I hate my neighbors.
$ delinquent house=/marion/south/102
Hahaha.
e-mail me with your address and stuff since PM's don't always work: sidoh@dark-wire.net
-
Check your PM's before I am forced to open some form of mail program/site.
-
Check your PM's before I am forced to open some form of mail program/site.
Hey, Sidoh, you have 24 messages, 0 are new.
:'(
-
I said "check" not "glance at the thingy up top".
-
I said "check" not "glance at the thingy up top".
This is the last thing I have:
u guys should be smart enough to know u cant stop me!!!!
Which was iago being silly.